sabbia@lampugnani.it
T +39 02 4884 0350
Ciclone con sistema a Venturi
The centrifugal cyclone or dust collector is a device capable to eliminate dust from the air using the centrifugal force principle. The dusted air coming from the sandblasting cabinet is pushed inside the cyclone system where a forced circular air current separates, by inertia, the heavier dust grains from the air, which fall from top to bottom in a recovery hopper to be subsequently re-circulated. The exhausted air can be further filtered with special filters, before being returned into the environment.
Ciclone con sistema in Pressione
To recognize a cyclone system, and therefore a real dust separation system and not a fictitious solution, it is necessary to check the position of the air/sand mixer .
If the mixer is located under the hopper of the machine, the system doesn't have a true separator cyclone system. In fact the heavy grit will inevitably fall down and put back into circulation circuit and fired again. Moreover, if the electric fan were able to remove residuals and burrs, it would also take away "good" material; this is because the cyclone-free systems only work on the weight difference of the powders present in the cabinet.
The mixer on Lampugnani sandblasting and shot-peening machines with cyclone is located just below the cyclone, where is the starting point of the sand, and its re-entry, will occur only after being centrifuged, sieved and separated from the cyclone itself.
To get the best results you need to use appropriate quality products. Lampugnani suggests a range of abrasives and non-abrasives products for sandblasting and shot peening treatments. Always in stock and ready for delivery, a full range products in different sizes, tested and guaranteed to be used on the entire range of Lampugnani Sandblasting Machines.
Fields of application
Mechanical, Molds, Aeronautical, Deburring, Decoration, Surface Cleaning
Dental Technique, Medical, Food, Shot-peening
Foundries, Removal, Roughness
Finishing, Restoration, Engraving, Surface roughness
Finishes on Glass, Wood Restoration, Decoration, Medical, Dental Technique
Molds, Surface Cleaning, Roughness